SpecificationHigh-speed Roller shutter, double-skinned, insulated, made of steel profiles, galvanised and coloured.
Resistance to wind load in accordance with EN 12424 class 2.
Make: Teckentrup High-speed Roller Shutter, steel profiles, double-skinned.
Drive: direct mount drive 400 V (three-phase voltage), IP54, 20 cycles (Open/Close) per hour, with emergency crank handle, integrated anti-drop device, TÜV tested, maintenance-free.
Control: in the basic version, with pulse control, soft start and soft stop
(application: fast running roller doors).
Integrated main switch with CEE plug.
Installation: behind the opening, all fixing material, matching the building structure will be attached.
Compile and tender according to requirements.
Please refer to technical data below for respective details. Updated 01.03.2023
Product High-speed Roller shutter (profiles made of galvanized steel, double-skinned).
Maximum opening speed up to 1500 mm/sec.
factory-set at 1000 mm/sec.
Durability test
Standardised durability test with 200,000 opening and closing cycles (roller door with drive)
Dimensions
Ordering dimensions
Width: 2.000 - 9.750 mm
Height: 2.550 - 8.750 mm
Resistance to wind load (EN 12424)
Up to width
class 1 in standard 9.750 mm
class 2 in standard 8.000 mm
class 3 in standard 5.000 mm
class 3 available (additional price) 7.000 mm
class 4 available (additional price) on request
Roller shutter for external use min. Requirement WL 2 (EN12424)
Door curtain Door curtain, consisting of hinge-like interconnected galvanized steel profiles.
Profiles:
Double-skinned steel, 94 mm wide
Surface Options:
Galvanized steel
Coil-coated steel
Prime coated steel
Glazing options
Synthetic glazing, crystal clear approx. 150 mm x 55 mm.
Bottom seal
Double-skinned box profile made of aluminium with permanently elastic and frost-proof EPDM
profile hose seal for a sealed bottom door edge.
End caps
Robust, wear and corrosion-free plastic parts for fixing the profiles.
Wind hooks
For high wind loads and/or large widths the doors are equipped with wind hooks and a reinforced bottom seal.
Guide rails
Robust steel profiles with wear-proof, easy-tochange plastic guides.
Winding shaft
Prime coated steel tub, with welded-in shafts on both sides for drive, anti-drop or bearing seat.
Drive
Direct mount drive with integrated anti-drop device or chain drive with separate anti-drop device
and electric forced disconnection, (three-phase volt.) 400V, 50Hz, 20/30 cycles*, degree of
protection IP54, with emergency crank handle, TÜV tested.
Other special voltages, degrees of protection or types of emergency operation on request.
* A cycle is a complete closing and opening operation of the door.
Control
For direct mount drives, with with pulse control (Control method for frequency inverter), soft
start and soft stop.
Fully wired ready for use an with CEE-plug.
Radio control optional
- Accessories for control units:
- Auto. closing
- Traffic light control/Two-way traffic
- Induction loop
- With self-monitoring light curtain. Safety-low control voltage 24V, IP 65, “close door“ and “open door“ in self-locking mode with push buttons “open-stop-close“.
Special equipment
Permanent side part with integrated door.
Pivoted side part with integrated door.
Curtain box made of:
Galvanized sheet steel
Natural aluminium
Other versions on request